User's Manual

Stegos – RS Receiver

2.5 How to operate the receiver

• Turn on the receiver with the on/off switch . The green power

on LED  will illuminate.

• The channel LEDs 1 to 4 will illuminate green to indicate the

availability. As soon as you turn on the first Stegos TB boundary

microphone, the channel LED 1 will illuminate  red to indicate

that the channel is occupied.

• At the factory the RF band “Low” has been adjusted. If inter-

ferences occur, you should change the frequency band. Use the

tip of a pencil or a paper clip to press the countersunk push-

button for RF band selection . The boundary microphones are

automatically set to the selected frequency band.









Wiring Phoenix terminal strips – rear view Stegos RS

+- - - - -+++ +

Shield

Hot

Cold