User's Manual

Stegos – Software
16
4.5 Settings
Connectivity Settings
• Depending if you have connected the Stegos RS receiver to the USB port or RS 232 interface, you can
select the appropriate Com port.
• When you have selected the Com port, select “Connect”.
• If the connection is to be set automatically after a reboot, tick the “Automatic Reconnect” tick box.
Microphone Status Viewer
• Here you can recognise which microphones are currently active or which microphones were active. The
active microphones display in addition to the serial number, device type and firmware as well as the
channel and RF quality.
• If the RF quality is okay, three bars are displayed. If the RF quality drops, the bars are reduced
correspondingly.
RF Channel Settings
• You can select among three frequency bands: Low, Mid, High.
• In order to set the microphones automatically to the selected frequency band, tick the “Microphone
Auto Lock” tick box.
• If the microphones are configured according to your requests you can deactivate the “Microphone
Auto Lock” tick box.
Tip
The function “Microphone Auto Lock” has the advantage that the microphones automatically search
for a Stegos RS receiver when turned on and are configured to this one. If you change the frequency
band (e.g. to avoid jamming sources such as Wireless LAN), the microphones automatically search for
a receiver again and are configured to the changed frequency band.
Mute Settings
• If you activate the “Toggle Mute” option, the microphone is activated when the push-button  is
pressed and deactivated when the push-button is pressed again.
• If you activate the “Push-To-Mute (PTM)” option, the microphone is always open and only muted,
when you hold down the push-button .