User's Manual

Stegos – Software
14
4.3 Putting into operation
• Turn on the Stegos RS receiver with the on/off switch  on the
rear.
• When the receiver is ready for use, the green Power on LED ,
the audio channel LEDs , the RF band LED  and the
appropriate LED  of the selected headphone channel will
illuminate on the front.
• Turn on the Stegos TB boundary microphones by pressing the
push-button .
• Start the software.
• When the Stegos RS receiver is connected to the RS 232
interface of your PC, select under “Connectivity Settings” in the
“Settings” menue the appropriate “Com” port and then select
“System Connect”.
Front view Stegos RS
Rear view Stegos RS
  


• For firmware and software updates please visit our homepage
www.beyerdynamic.com
Stegos TB