User's Manual

Stegos – TB Boundary Microphone
12
3.3 How to recharge
• Before the Stegos TB boundary microphone is used for the first
time, you have to recharge the integrated rechargeable batteries.
• In order to recharge the batteries connect the supplied mains
charger adapter to the microphone  and a power socket. The
LED  will illuminate briefly for one time. The charging time is
approx. 2 hours.
• The LED  displays the charging process:
LED flashes red . . . . . . . . . . . . . . . Charging in process
LED illuminates permanently red. . Battery is full
LED flashes slowly red. . . . . . . . . . Normal charging process
LED flashes rapidly red . . . . . . . . . Error (in this case disconnect
the mains charger adapter,
then connect again; if needed
phone the support staff)
• The operating time of the rechargeable batteries integrated in the
Stegos TB boundary microphone is at least 14 hours.
The LED  on the rear displays a reduced battery charge. When
the LED  starts flashing green, the maximum operating time of
the batteries is still approx. 1 hours. The Stegos software displays
the battery status in per cent.
Important:
• Depending on the kind and time of use as well as the number of
charging cycles, rechargeable batteries are subject to a natural
aging process reducing the total capacity and the maximum ope-
rating time.
• It is normal that rechargeable batteries are heated up during the
charging process.
• If the boundary microphone is turned on while charging, the
LED  will illuminate green.
 


c) Press the stand-by push-button  of the Stegos RS receiver.
d) Turn off the Stegos RS receiver via the on/off switch  on
the rear of the Stegos RS receiver.
e) Select the “Power off” push-button in the Stegos software.