User's Manual

MIX 10 NG2 – RS 232 Interface
30
Sent Commands
The following commands are sent from the MIX 10 NG2:
“10” ~ “15” represent the channels MIC1~MIC6.
“00” ~ “04” represent the channels LINE, SUB-L, SUB-R, MASTER-L,MASTER-R.
An acknowledged message is directly sent from the MIX 10 NG2 after having received a request.
Example:
Selection of the CD line input
DLE STX Device No. Len Cmd Data DLE ETX Check Sum
10 02 01 02 A1 03 10 03 A0
Cmd Data0 Data1 Command Data0 Data1
C1 00~04 Line source selected line 1 - 4 or none(0)
C2 00~4F 00~04 Stereo volume currently adjusted
value “N”
N - value stereo no
C3 00~4F 10~15 Mic volume currently adjusted value
“N”
N - value mic no
C4 00~4F 00~04 Stereo volume now value “N” N - value stereo no
C5 00~4F 10~15 Mic volume now value “N” N - value mic no
C8
2
0
Bit 0 Auto ducking 1 = on , 0 = off
2
1
Bit 1 Ducking manually
1 = on , 0 = off
C9 00~01 10~15 Mic ducking
01 = enabled ,
00= disabled
mic no
CA 00~01 01~02 Stereo ganged
01 = enabled ,
00= disabled
01 = sub group,
02 = master
CB 00~03 00~01 Load or save preset 0-default / preset 1,2,3 00 = load , 01 = save
CE 00~01 00~04,10~15 Mute flag 1 = on , 0 = off stereo / mic
D0 00~7F Fade-out speed N - value
D1 00~7F Fade-in speed N - value
D2 00~7F Ducking threshold value N - value
D3 00~4F Ducking reduction N - value
D4 00~7F Ducking hold N - value
D7 00~03 Switch-on status preset 1/2/3/switch-off
status(0)
D8 Programmed version (V 1.0)
PC –> Device
MIX10NG2_BA_DE_2008:MIX10NG_BA_DE 01.02.2008 10:30 Uhr Seite 30