User's Manual

MIX 10 NG2 – RS 232-Schnittstelle
14
Sendebefehle
Folgende Befehle werden vom MIX 10 NG2 gesendet:
„10“ ~ „15“ steht für Kanäle MIC1~MIC6.
„00“ ~ „04“ steht für die Kanäle LINE, SUB-L, SUB-R, MASTER-L,MASTER-R.
Eine Bestätigungsnachricht (Acknowledge) wird vom MIX 10 NG2 direkt nach Empfang einer Anforderung gesendet.
Beispiel:
Auswahl des CD-Line Eingangs
DLE STX Device No. Len Cmd Data DLE ETX Check Sum
10 02 01 02 A1 03 10 03 A0
Cmd Data0 Data1 Command Data0 Data1
C1 00~04 Line source selected line 1 - 4 or none(0)
C2 00~4F 00~04 Stereo volume currently adjusted
value “N”
N - value stereo no
C3 00~4F 10~15 Mic volume currently adjusted value
“N”
N - value mic no
C4 00~4F 00~04 Stereo volume now value “N” N - value stereo no
C5 00~4F 10~15 Mic volume now value “N” N - value mic no
C8
2
0
Bit 0 Auto ducking 1 = on , 0 = off
2
1
Bit 1 Ducking manually
1 = on , 0 = off
C9 00~01 10~15 Mic ducking
01 = enabled ,
00= disabled
mic no
CA 00~01 01~02 Stereo ganged
01 = enabled ,
00= disabled
01 = subgroup,
02 = master
CB 00~03 00~01 Load or save preset 0-default / preset 1,2,3 00 = load , 01 = save
CE 00~01 00~04,10~15 Mute flag 1 = on , 0 = off stereo / mic
D0 00~7F Fade-out speed N - value
D1 00~7F Fade-in speed N - value
D2 00~7F Ducking threshold value N - value
D3 00~4F Ducking reduction N - value
D4 00~7F Ducking hold N - value
D7 00~03 Switch-on status preset 1/2/3/switch-off
status(0)
D8 Programmed version (V 1.0)
PC –> Device / Gerät
MIX10NG2_BA_DE_2008:MIX10NG_BA_DE 01.02.2008 10:29 Uhr Seite 14