User's Manual

MCW-D 50 Control Unit

RS 232 port for the connection of PC or media control system (9-pin Sub-D)

LAN network connection for PC

Control LED for antenna powering 5 V DC (green = normal DC ; flashing red rapidly = short circuit)

Switch -10 dB / +15 dB for unbalanced input (RCA)

Input, RCA, unbalanced, for the connection of external devices such as CD players (L + R)

Output - master output, RCA, unbalanced, for the connection of external devices such as mixing consoles,

sound contracting systems or recorders (L + R)

Level control for Output - master output, RCA

Switch -10 dB / +15 dB for balanced input (XLR)

Input, 3-pin XLR female, balanced, for the connection of external sound sources (+6 dBm)

Output - master output, 3-pin XLR male, balanced, for the connection of external devices such as mixing consoles,

or sound contracting systems

ON/OFF-switch

Fuse

Mains supply

Connection for receiving antennae

Connection for transmitting antenna

Power LED. LED is illuminated green when the unit is switched on.

Standby button. When this button is pressed for more than 3 seconds all switched-on microphone units are switched off.

When this button is pressed shortly all allocated microphones are switched off.

Reset. This button resets the system into the switch-on state (to press the reset button use a paper clip).

LEDs to indicate the status of the receiving channels. LED is illuminated green: the channel is vacant.

LED is illuminated red: the channel is occupied.

Volume control for the loudspeakers of the microphone units

Rear

3.2 Setting up

3.2.1 Where to place the Control Unit

• If you do not use remote antennae*, place the MCW-D 50 control unit in the room where the meeting takes place. If you use

remote antennae*, place them in the conference room.

• Do not place the MCW-D 50 control unit near digitally controlled equipment.

*Important note for the USA and Japan: At present only the use of the CA 2413 remote antennae is permitted.

6 7

11 12 13 14 15 16 17 18

192019