Datasheet

CUSTOM HEADSET GEAR
beyerdynamic GmbH & Co. KG
Theresienstr. 8 | 74072 Heilbronn – Germany
Tel. [phone] / 617 - 0 | Fax [phone] / 617 - 204
[e-mail] | www.beyerdynamic.com
For further distributors worldwide, please go to www.beyerdynamic.com
Non-contractual illustrations. Contents subject to change without notice. E2/CUSTOM ONE GEAR (06.13)
2 of 2
FREQUENCY RESPONSE & POLAR PATTERN
This polar pattern and frequency response curve (± 3 dB) correspond to a typical production sample for this microphone.
WIRING DIAGRAM
OPERATING INSTRUCTIONS
• Remove the pop shield from the microphone.
• Connect the cable to the CUSTOM ONE PRO headphone.
• Connect the microphone to the jack socket of the cable and
adjust the microphone as shown in the illustration.
• Please note that the slotted side is the rear of the microphone.
Make sure that it points away from the mouth. Refer to the arrow.
• Put the pop shield over the microphone again.
Warning:
In order to avoid overstretching and premature wear and tear never
bend the gooseneck more than 90°.
Rear of the microphone.