User Manual

Byron BTA – In-ear headset
1
2
• Press the MFB button for around 4 seconds until the blue
L
ED is continuously on.
• Please pair the Bluetooth in-ear headset to the 2nd device
according to the pairing process.
• Then, turn off the Bluetooth in-ear headset and turn on
again, it will be connected to two devices.
How to use Multi point
• At the status of connecting two devices, press the MFB
button to answer a call when there is an incoming call.
• At the status of connecting two devices, press the MFB
button to listen the music that was played lately.
8.3 Call
• Answering a call:
Press the MFB button to answer a call.
• Ending a call:
Press the MFB button shortly to end a call.
• Rejecting a call:
During an incoming call, press the MFB button for about
1 second.
• Converting a call:
During a call with mobile, press the MFB button to convert
to the headset (to call with the mobile again, use your
mobile phone menu).
• Volume control:
With the + and – buttons you can control the volume.
• Microphone Mute:
If you press the + or – button for about 1 second during a
call, the microphone will mute.
During mute, it will be released, if you press the – button
for about 1 second.
• A waiting call and putting a call on hold:
This feature allows you to put a call on hold during a
conversation and answer a waiting call.
Press the + button for approximately 1 second to put an
active call on hold and answer a waiting call.
Give the + button a long press to switch between two calls.
To end a call press the MFB button briefly.
8.4 Factory reset
• Press the buttons in the following order:
The purple LED will glow and the in-ear headset will be
initialised. After a factory reset, pair the in-ear headset
again for use.