User manual

26 BC615 Installation and User Manual
Set password
The first thing to do before starting to program the card reader is to set
a password.
1 Open the card reader with the key supplied. The lock is located on
the underside of the card reader.
2 Press and hold the SW1 button (see wiring diagram on page 16)
until the card reader starts beeping.
3 Enter the desired 6-digit password on the card reader’s keypad.
The password is now set.
Set the card reader to programming mode
To program a function, the card reader has to be in programming mode.
Proceed as follows:
1 Press B. 
2 Enter the 6-digit password. 
The card reader is now in programming mode.
Note! If the wrong password is entered two times in succession, the
card reader is blocked from further attempts for 40 seconds. From then
on the card reader is blocked for 40 seconds each time two incorrect
passwords are entered.