Technical information

Bewacard 610 Technical Manual 25
Choose/change PIN code
To choose/change your individual PIN:
1 Press A on the card reader’s keypad.
2 Swipe your card through the card reader.
3 If it is the first you are choosing a PIN code for this card, enter
0000. Otherwise enter the existing code.
4 Enter the new code using four digits.
5 Enter the new code again.
You have now set the PIN for your card.
Duress
To activate the Duress alarm output if forced to open the door under
threat (this works during the Card + PIN security level only):
1 Swipe the card through the card reader and enter the usual PIN
code, only add 1 to the last digit in the code.
Example 1: If the PIN code is 1234, press 1235 instead.
Example 2: If the PIN code is 1239, press 1230 instead.
When a duress code is entered, the door is opened at the same time as
the alarm output is activated (an alarm is sent to a security guard or
similar). The alarm output will be activated until it is reset by entering
programming mode.