Technical information

18 Bewacard 610 Technical Manual
Erase the memory and reset the default settings
When the card reader’s memory is erased, the default settings are
restored (see below).
1 Set the card reader to programming mode.
2 Open the card reader with the key supplied. The lock is located on
the underside of the card reader.
3 Press the SW1 button (see the wiring diagram on page 8).
4 Press 112186.
5 Press 112186 one more time.
All previously logged on cards have now been erased. The card reader
reverts to the following settings:
• Password: 112233
• Common code: None
• Opening time: 7 seconds
• Toggle security level: 0
• Card parameters: Position 9-16, the last 8 positions if fewer than
16 positions.