Technical information

12 Bewacard 610 Technical Manual
Programming
In the sections below are the instructions on how to program BC610.
To be able to program the card reader you have to set the card reader to
programming mode. This is done by entering a six-digit code (see the
next page).
Buzzer and LEDs
During programming you will be guided by the buzzer and the LEDs.
In this manual the LEDs are illustrated in the following way:
 = Off z = Lit  = Flashes
In programming mode before a function is chosen: All three LEDs
are flashing. 
During programming: The LEDs are lit or off depending on the
function being programmed.
Correct programming: Confirmed by a rising signal consisting of two
quick beeps.
Faulty programming: Confirmed by a falling signal consisting of one
long and one short beep.
Note! If, having entered programming mode, no key is pressed within
20 seconds, the unit will leave programming mode.