Specifications

Chapter 4. Installing the Camera and Connecting a Cable
N35110 Installation User Manual
15
Step 4: put the connectors inside a junction box. The junction box must be protected
enough to prevent water getting inside it.
IMPORTANT!
A junction box is not supplied with the N35110 and you need to purchase it separately. Recommended
dimensions are 100х100х50.
4.4. Wired Connection to a Network
Step 1: provide power to the camera using either of the following ways (see paragraph 4.1):
 Over a twisted pair cable using PoE technology.
 Through the camera’s power cord socket using the supplied power adapter.
IMPORTANT!
Simultaneous power supply over PoE and the power connector is prohibited!
IMPORTANT!
Use only the power supply that is included with the N35110 camera or a compatible power supply that
meets the following requirements: DC voltage of 12 V, current strength of 1 A.
Step 2: use an RJ45 network cable to connect the camera to a network.
If needed, you can purchase a network cable separately or if you have the materials, tools
and skills, you can make a network cable.
A straight RJ-45 cable (UTP category 5)
The table below shows an example of a patch cord to connect the camera to a computer or
a network switch.
One end
Other end
1: White and orange
1: White and orange
2: Orange
2: Orange
3: White and green
3: White and green
4: Blue
4: Blue
5: White and blue
5: White and blue
6: Green
6: Green
7: White and brown
7: White and brown
8: Brown
8: Brown