User manual

Chapter 4. Managing the IP Camera via Internet Explorer
N300 Operations User Manual
11
4.1. Installing ActiveX Control Module
To view camera image trough Internet Explorer, you need to install ActiveX add-on. To do
so, follow these steps:
IMPORTANT:
The installation of ActiveX components is available to the 32 bit version of Internet Explorer only.
NOTE:
The installation is shown for Internet Explorer 9.0 and Windows 7.
Step 1: open Internet Explorer, type the IP address of your camera in the address bar.
Press [Enter] or click [Go To] button.
NOTE:
Before using the camera check that the camera and PC IP addresses are in the same subnet. In other
words the IP address of your PC should be 192.168.0.xxx.
Step 2: you will see an authorization window where you should enter your username and
password (Pic. 4.2)
Pic. 4.2
IMPORTANT:
Default username is admin, default password is admin.
Step 3: after first successful authorization, Windows 7 blocks the ActiveX add-on
installation on default. You will see a system notification at the bottom of the window: “This
webpage wants to run the following add-on: “AxMediaControl ActiveX Control Module”
from “BEWARD Co., Ltd.” (Pic. 4.3).