BEVOi INSTRUCTION MANUAL Models: BVIREF10SS BVIREF10W as Please read the Manual carefully before use.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-4 Location of Parts 5 Installation Instructions 6-10 Before Using your Appliance 6 Installation of your Appliance 6 Leveling your Appliance Electrical Connection 6 7 Extension Cord 7 Reversing the Door Sw/ng 8-10 Operating Instructions 10 Care and Maintenance 11-12 Cleaning your Appliance 11 Cleaning the Glass Shelves 11 Defrosting 11 Power Failure 11 Moving 12 Vacations 12 Troubleshooting 13 Limited Warranty 16
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the word DANGER or WARNING.
● ● ● ● In the event of any damage: o Avoid open flames and anything that creates a spark, o Disconnect from the power supply o Air the room in which the appliance is located for several minutes and o Contact the Service Department for advice. The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
LOCATION OF PARTS vf fserfHr wifp iheir $ i D
INSTALLATION INSTRUCTIONS Before Using your Appliance ● Remove the exterior and interior packing. ● Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. ● Clean the interior surface with lukewarm water using a soft cloth. ● Install the handle on the door, if it is not already attached.
Electrical Connection WARNING Improper use of the grounded plug can result In the risk of electrical shock. If the power cord Is damaged, have it replaced by a qualified electrician or an authorized service center. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of electrical shock.
Reversing the Door Swing If you find the direction of opening the door of the appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory. To reverse your door, follow the instruction on the next page. Tools needed: ● Phillips head screwdriver ● 5/16” socket and rachet 1. Unplug the appliance, and remove all items from the door shelves and the interior. 2. Remove the hinge hole cover from the top left side of the appliance. 3.
. Carefully tip the unit back, and remove the adjusting feet, lower hinge screws, and the lower hinge assembly. 10. Install the lower hinge assembly on the other side of the cabinet, and install the adjusting feet again. Lower hinge assembly screw 11. Dismantle the limit blocks and screws on the lower cover of the refrigerator and freezer door. Install them on the opposite side of both doors. Then, install the sleeve pipe on the upper cover of the refrigerator door on the other side.
13. Set the freezer door onto the middle hinge, and then install the upper hinge to secure the freezer door, making sure to secure the hinge cover and hinge hole cover. hole cover hinge cover screw rif upper hinge Changing the Interior Light Replacing the LED lamps should be done by the manufacturer or qualified technician. OPERATING YOUR APPLIANCE Control Panel -a @ CO..Drf-: .« ● The control panel features a SET Q key and five temperature settings.
CARE AND MAINTENANCE CAUTION: Be sure to unplug the appliance before cleaning to avoid the risk of electric shock. Cleaning your Appliance ● Dust accumulates behind and on the unit should be cleaned regularly to ensure cooling efficiency and energy consumption, ● Check the door gasket regularly to make sure there is no accumulated debris. Clean the door gasket with a soft cloth dampened with soapy water or diluted detergent.
Moving ● ● Before the unit is moved, remove all of the items stored inside, fix the glass shelves, drawers, freezing chamber drawers, etc, with tape, and tighten the leveling feet. Then, close the doors and fix them with tape. During moving, the appliance shall not be laid upside down or horizontally, or be vibrated; the inclination during movement shall be no more than 45°. Vacations ● ● Short vacations: Leave the appliance operating during vacations of less than three weeks.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Check whether the appliance is connected to power or whether the The unit stops plug is in well contact. working. Check whether the voltage is too low. Check whether there is a power failure or partial circuits have tripped. Tightly wrap food to prevent possible odor.
