Installation manual

BT30CWFMS
GROUNDING
This appliance is equipped with a three-prong (grounding) plug for your protection against
shock hazards and should be plugged directly into a properly grounded three-prong
receptacle. Where a two-prong wall receptacle is encountered, it must be replaced with a
properly grounded three-prong receptacle in accordance with the national electrical code
and local codes and ordinances. The work should be done by a qualified electrician. (See
figure below.) Do not, under any circumstances, cut or remove the round grounding prong
from this plug.
WARNING
Consult a qualified electrician if you have any doubt about the grounding of your wall
receptacle. Only a qualified electrician can determine the polarization of your wall
receptacle, and only a properly installed three-prong receptacle assures the proper
polarization of your wall receptacle, and only a properly installed three-prong receptacle
assures the proper polarization with the appliance plug.
GROUNDING
TYPE WALL
RECEPTACLE
POWER SUPPLY
CORD WITH 3-PRONG
GROUNDING PLUG
FLAMMABLE MATERIAL STORAGE
To meet requirements for storing flammable material, cabinet has no opening, other than the
door, or any electrical components below compressor compartment.
NOTE: Do not modify cabinet or remove flammable material storage label on the front.
DEFROSTING & CLEANING
A complete defrost will be required periodically, depending on the usage of the cabinet. To
defrost, perform the following:
1. Unload product from the cabinet.
2. Pull power supply cord from wall receptacle.
3. To hasten process, set pans of warm water on shelves of storage compartment, or let a fan
blow into the storage area with the door open.
4. Wipe all the shelving and wall surfaces clean and dry.
5. Remove the shelves and shelf standards, if necessary for thorough cleaning.
6. Return all components. Plug in power supply cord.
7. Once the cabinet has attained desired temperature, reload the cabinet with product.
NOTE:
The door may be hard to open for a short period after closing. Wait a few seconds to allow
interior air pressure to balance.