Installation manual

PERIMETER HEATER REMOVAL
1. Disconnect power to cabinet.
2. Allow trim to warm up.
3. Insert the edge of the putty knife 1/16" under the
outer flange of the trim breaker.
4. Rotate handle down to approx. 45°.
5. Bump the putty knife handle until breaker trim
releases (see figure 1).
6. Remove all trim in the same manner.
7. Locate perimeter heater exit points.
8. Pull defective heater from groove provided.
9 The perimeter heater is plugged into a terminal
board located in the upper of lower raceway
depending on the application.
10. Install new heater and reseal wire exit points.
11. Replace trim and seal with a silastic compound.
74 MAINTENANCE & REPAIR