Installation manual

DOOR GASKET REPLACEMENT
The gasket is replaceable on glass or solid door models.
A retainer is molded into the door frame.The door gasket
is then tapped into the retainer and secured for airtight
door seal.
1. Remove door from cabinet.
2. Lay door front down on a flat, firm, nonscratch surface.
3. Pry up one corner of gasket with a putty knife or
screwdriver. Pull gasket from perimeter of door
retainer. Clean new gasket and straighten to insure
proper fit.
4. Pull gasket from perimeter of door retainer.
5. Clean new gasket and straighten to insure proper
fit.
6. Place gasket over retainer in door frame.
7. Using a rubber mallet, tap the gasket into the
retainer. (NOTE: Gasket can be soaked in warm
water to make pliable.)
8. Place door back onto cabinet.
MAINTENANCE & REPAIR 65