Installation manual

EVAPORATOR FAN MOTOR REPLACEMENT (Rear Fan)
1. Disconnect the power to the cabinet and locate the
evaporator fan in the cabinet interior behind the
evaporator coil.
2. Remove the fan guard by rotating it counter
clockwise to the position shown.
3. Remove the fan and bracket assembly by rotating it
to the position shown.
4. Lower the fan assembly and remove the two screws
that fasten the motor to the bracket.
Note: To assist the removal of the guard and bracket,
press on the detent bumps to guide them out of the
obround holes.
MAINTENANCE & REPAIR 57