Owners Manual

User Manual for DD Refrigerators Beverage-Air
Rev. 12/20 Beverage-Air 9
Leveling:
Cabinets must be leveled when installed. Level should be
measured on the headrail.
Failure to level your cabinet may result in door not sealing,
closing correctly, or condensed water draining not draining
properly.
For cabinets with legs, rotate the foot of the leg with an
adjustable wrench to achieve desired height for leveling.
For cabinets with casters, leveling can be achieved by
placing large washers in between the ½’ stud and the holes
located on the bottom of the case.
Do NOT loosen casters to level
the cabinet. Casters MUST be
tightly secured to cabinet for full
strength.
Install or attach any accessories that will be used
Remove any plastic covering the stainless steel.
Installation of Draft Arms
Place rubber washer over draft arm mounting holes in
cabinet top and put beer line connector down through the
hole. Secure each draft arm with the four bolts provided.
Place air hose clip over beer line and insert one inch plastic
hose in draft arm being careful not to disturb insulation.
Remove top cover of draft arm and attach air hose clip to
the ¼” stainless steel elbow at faucet connection. Replace
top cover. This clip assures that the air hose remains in
place to keep the beer faucet cold.
CO2 Line Routing
For permanent installations a “knockout’ plug has been
provided through which the CO2 line can be extended
CAUTION
UNPACKING AND SET UP (CONTINUED)