CDRHC SERIES 3779 Champion Blvd Winston-Salem, NC 27105 Phone: 336-245-6400 Fax: 336-245-6453 INSTALLATION AND OPERATION MANUAL Congratulations! You have just purchased the finest commercial refrigeration available. CDR6HC-1-B CDR3HC-1-B CDR5HC-1-B www.beverage-air.
TABLE OF CONTENTS APPLICATION .................................................................................................................................... 3 PRODUCT REGISTRATION................................................................................................................ 3 DIRECTIONS FOR STORAGE AND HANDLING THE EQUIPMENT.................................................. 3 STORAGE OF THE EQUIPMENT .....................................................................................
ADDITIONAL WARNING - Please use care when moving or handling this equipment. It is equipped with flammable refrigerant and damage to refrigerant tubing will increase the risk of a leak. -When service is required, seek factory authorized technicians trained to safely maintain and service systems that utilize flammable refrigerants, such as R290. RSES offers such training and certification. -Use factory authorized replacement parts to minimize the risk of possible ignition.
MOVING THE EQUIPMENT The unit is constructed to facilitate using a forklift to handle it. Use this handling means to move the equipment as close as possible to the location where it will be installed. IMPORTANT: Never push, pull or strike the front or rear glass. PLACING AND INSTALLING EQUIPMENT ENVIRONMENTAL CONDITIONS THIS UNIT CANNOT BE INSTALLED IN ENVIRONMENTS WITH EXPLOSIVE GASES. THE EQUIPMENT IS DESIGNED ONLY FOR INDOOR OPERATION.
Before connecting your equipment, check that the electrical data on the data plate match your electrical output. IMPORTANT NOTICE: PLUG THE EQUIPMENT INDEPENDENTLY TO A LOAD CENTER WITH AN APPROPRIATE CIRCUIT BREAKER ACCORDING TO THE NAMEPLATE AMPS. POSITIONING SHELVES The shelves and holders have been fixed to the inside floor of the unit to prevent their loss during transportation.
COMPRESSORS The CDRHC series of units have a single hermetic compressor. CONDENSERS The CDRHC units incorporate a “maintenance free” condenser design in the refrigeration system which reduces the need for the regular cleaning process that fin and tube condensers require. Besides the savings in preventive maintenance costs, energy expenses will be stable throughout long periods of time since the condensers will remain “clean and unobstructed”.
CAUTION The equipment has been exclusively designed to maintain the proper temperature of packaged fresh food and beverages. Because the unit is not designed to cool the product down quickly, the product must be loaded at its appropriate temperature. - Do not remove grilles or panels that require using tools to be accessed - Do not keep the unit running unloaded. UNPLUG IT when you are not planning to use it. Using any electrical or electronic equipment entails the compliance with some fundamental rules.
MAINTENANCE GUIDELINES CONT’D CLEANING THE CONDENSER COIL IMPORTANT WARRANTY INFORMATION: Condensers accumulate dirt and require regular cleaning. Dirty condensers result in compressor failure, product loss, and lost sales; which are not covered by warranty If you keep the condenser(s) clean you will minimize your service expense and lower your electrical costs. The following is a step-by-step guideline for the cleaning of the condenser(s): 1. 2. 3. 4. 5. Disconnect power to the unit.
This page intentionally left blank www.beverage-air.
TECHNICAL ASSISTANCE If technical personnel assistance is required, you must immediately contact your distributor, specifying the kind of problem and clearly indicating the equipment model and serial number. If replacing parts is required, do it through your distributor.
