Assembly Instructions

CHAIR ASSEMBLY INSTRUCTION GUIDE
for BEVCO V4/V7/V8 Series Non-Tilt Models
VALUE - LINE
Footring
(optional)
(1)
Glides/Casters
(5)
Seat w/control
Mechanism
(1)
Pnuematic
Cylinder
(1)
Back Support
w/Integrated
Support Bar
(1)
PARTS LIST
Five-star Base
(1)
Support bar
(1)
Insert glides or casters into each leg
of the base.
Slide footring (if enclosed) onto
cylinder. Ensure the tubular ring faces
upward. Tighten handwheel securely.
Slide the cylinder into the center of
the base.
1 2 3
4 5 6
Remove handwheel and white washer
from hinge assembly on back. Slide
screw through slot in back support
bar so it is aligned with the two raised
squares on hinge assembly, then
position white washer against back
bar and then tighten handwheel
securely.
Slide bottom of back support bar into
the opening of the control mechanism
underneath back of seat. Tighten
handwheel securely.
Place seat with control mechanism
onto the end of the pneumatic
onto cylinder.
Seat w/control
mechanism
GLIDE/CASTER
ASSEMBLY
DETAIL
▸Regularly clean your chair– vacuum fabric,
wipe down vinyl and polyurethane with a mild
detergent weekly
▸Immediately remove chair from service if
any damage or failure is found and contact
Bevco Customer Service at
800-864-2991 or email [e-mail]
▸Clean casters (if applicable) by
vacuuming or using compressed
air to remove and accumulated
dust, debris or hair.
Add silicone lubricant if needed.
Recommended
Chair Maintenance
▸Check that all bolts, screws and knobs
are securely tightened every six months
or as needed