User manual

10
Repairs
Important
 • Pleasedonotattempttorepairtheunityourself.Thiscouldresultinseriousinjuries.Failuretoobserve
this regulation shall void the warranty.
 • Ifyouneedtohavetheunitrepaired,contactcustomerserviceoranauthoriseddealer.
4. Unit description
Overview
1. Fluorescent screen
2.Rearofthedevicehousing
3. Support feet
4.On/offbutton
5. Mains cable with plug
6. Stand
7. Hole for wall-mounting fixture
5. Initial use
Afteropeningthepackagingchecktoensureitcontainsallthepartstobeincludedindelivery.
Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 20cm and
40cm between the user and the device. The lamp is most effective at this distance.
Mounting the device on the wall
Alternatively,youcanalsomountthedeviceonthewall.Thisrequiresasolidwallwithastablesuspensionde-
vice(forconcretewallse.g.a25mmlongM4stainlesssteelself-tappingscrewandwallplug).Onlymountthe
deviceonthesuspensiondeviceatthehole(locatedcentrallyontherearofthedevice).Self-tappingscrewand
wall plug are not included in delivery.
Important:
If the area around the hole in the rear of the device is cracked or damaged, do not mount the device on the
wall!Forhelp,pleasecontactcustomerservicesoryourretailer.
Mains connection
Connect the unit only to the mains voltage listed on the type plate. Push the plug completely into the mains
socket.
Note:
 •Ensurethatthereisasocketneartheplacewherethelampwillstand.
 •Laythemainscableinsuchawaythatnoonecantripoverit.
6. Operation
1 Switching on the lamp
PresstheOn/Offbutton.Thetubesturnon.
The tubes develop their full luminosity after a couple of minutes.
1
2
3
4
7
6
5