SDS

B3C Better Than Oil Bar and Chain Lubricant
Conforms to OSHA 29 CFR 1910.1200 and aligns to the United Nations Globally Harmonized System
Page 4 of 7
8.5 Personal protective equipment
Respiratory protection Respirator not required for normal use
Where risk assessment shows, use air-purifying respirators are appropriate to use a full-face respirator with multi-
purpose combination (US) or type AXBEK (EN 14387) respirator cartridges as a backup to engineering controls. If
the respirator is the sole means of protection, use a full-face supplied-air respirator. Use respirators and
components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).
Hand protection Gloves are not required for normal use
Handle with gloves. Gloves must be inspected before use. Use proper glove removal techniques to avoid skin
contact with this product. Dispose of contaminated gloves after use. Select gloves tested to the ANSI/ISEA 105-
2011 or European EN374 Standard.
Full contact: Viton
Splash contact: Viton
Eye protection Not required for normal use
Face shield and safety glasses Use equipment for eye protection tested and approved under appropriate
government standards such as NIOSH (US) or EN 166(EU).
Skin and body protection Not required for normal use
Impervious clothing: The protective equipment must be selected according to the concentration and amount of the
dangerous substance at the specific workplace.
8.6 Protective Clothing Pictograms
Section 9 - Physical and Chemical Properties
9.1
Physical State: Liquid
Appearance: Various
Odor: Characteristic order
Vapor Pressure: Not Available
Vapor Density (Air=1): Not Available
Specific Gravity (H2O=1,): Not Available
Relative Density: Not Available
Odor Threshold: Not Available
Flammability (solid, gas): Not applicable.
Evaporation rate: Not Available
Partition coefficient octanol/water: Not Available
pH: None
Water Solubility: Not Available
Flash Point: Not Available
Boiling Point/Range: Not Available
Lower Explosive Limits (vol % in air): N/A
Upper Explosive Limits (vol % in air): N/A
Melting Point: Not Available
Viscosity: Not Available
Autoignition Temperature: Not Available
Decomposition temperature: Not Available
Section 10 - Stability and Reactivity
10.1 Stability: Stable under ordinary conditions of use and storage.
10.2 Polymerization: Hazardous polymerization has not been reported.