Operating instructions

Setting Up your Handheld Transmitter (Wireless Mic.)

To change frequency/channel press set until LCD screen displays CH

001* (channel display values) or 750.000* (frequency display values)

(*varies depends on current settings). Press the up or down buttons to select a

different channel/frequency (channel ranges from 1-9 & A-F). Then the LCD

screen will flash. Press set again to confirm (if you don’t confirm no adjustments

will be made.)

Match your frequency/channel to the receiver’s the RF indicator on the

receiver will show a signal.

To change display between frequency/channel:

Frequency displays frequency signal’s actual units, while channel displays

a substitute letter or number. (Refer to pg.20 for the frequency’s value in

channel and actual unit)

Keep pressing set until LCD screen displays “disply”. After 1-2 seconds

screen will show FYE 9u (for frequency) or CHAnnl (for channel). Note: Current

display depends on settings. Press the up or down button to switch between

the two. Then the LCD screen will flash. Press set again to confirm (if you don’t

confirm no adjustments will be made.)

To unlock/lock your settings:

In lock mode settings can not be adjusted and transmitter can not be

powered off, in unlock mode all settings can be adjusted.

Keep pressing set until LCD screen displays “loc Set” after 1-2 seconds

screen will display Loc OFF (unlock) or Loc on (locked). Press up or down to

switch between the two settings. Then the LCD screen will flash. Press set

again to confirm (if you don’t confirm no adjustments will be made.)

CH 002

NOTE