Operating instructions

Third, Pull open handle to reveal the transmitter’s LCD monitor.

When pulling out handle make sure that you pull it straight out then

when you hit a click wedge the handle a little bit and it will loosen, then pull it

straight out.

Fourth, to change the settings press set to switch to the mode you want to

adjust on the transmitter, and up and down to select press set again to

confirm. When the battery is low the light above the LCD screen will be

flashing.

To modify the other modes, press “SET” to that mode and the “

▲

”and “

▼

” button to select the adjustments. Press “SET” again to confirm.

Match your frequency on the transmitter to those on the receiver for a

better signal.

If you do not press set to confirm no adjustments will be made.

Damage because of improper usage will void your warranty.

CH 002

VM-99U

WIRELESS SYSTEM ENGINEERING IN USA

NOTE