® ® Unlike any others ... that’s cost & value for you Professional UHF Wireless Microphone System VM-82U G3 Operating Instructions G3 SERIES Generation 3 UHF Frequency Selectable U HF W LE 835. 500 IRE BA T SS SY ST EM VM -8 2U G3 MICROPHONE 1 IR PEAK UHF VOLUME MIN MAX RF µV 100 PEAK % 100 60 60 25 25 5 5 DEV ® FREQUENCY SYNC MUTE 835.
CONTENTS INTRODUCTION................................................................................ 1 Intro SYSTEM FEATURES............................................................................. 1 Features Package Base Module hand-held Operation PACKAGE ACCESSORIES................................................................... 2 2-in-1 BASE MODULE........................................................................ 3 • Controls and Functions..............................................
INTRODUCTION Intro Better Music Builder VM-82U G3 is a third generation wireless microphone that uses the latest UHF wireless technology. It is the most advanced and customizable wireless microphone system we have to offer. Its sleek design features heavy duty UHF dual-channel microphones, built-in LCD panels, Wireless Infrared Auto Sync System, 30 unique channels for each microphone, and ultra long battery life.
PACKAGE ACCESSORIES Package The package comes with one 2-in-1 Base Module [Receiver], two handheld microphones, two antennas, one DC adaptor, one unbalanced audio cable, and four AA batteries. MICROPHONE 1 IR PEAK UHF VOLUME MIN MAX RF µV 100 PEAK % 100 60 60 25 25 5 5 DEV ® FREQUENCY SYNC MUTE 835.
2-in-1 BASE MODULE [RECEIVER] Base Module CONTROLS AND FUNCTIONS MICROPHONE 1 IR PEAK VOLUME UHF MAX MIN 1 RF µV 100 PEAK % 100 60 60 25 25 5 5 DEV 2 3 ® FREQUENCY SYNC MUTE 835.
LCD PANEL: After turning on the “POWER” button, LCD screen will display the following: 11 PEAK RF µV 100 PEAK % 100 60 60 25 25 5 5 DEV 15 12 13 14 FREQUENCY SYNC MUTE 835.500 CH:01 SQ:6 16 17 18 19 GHz MHz ANT A ANT B 20 11. SYNC: Shows that synchronization is in progress. 12. MUTE: Shows that microphone is not set up or Off. 13. LOCK/UNLOCK: Shows whether current settings are locked. 14. BATTERY STATUS: Shows battery level of microphone. 15.
HARDWARE SETUP Set Up HOW TO CONNECT AUDIO OUTPUT: There are three rear outputs as shown in the below diagram: ANTENNA-B 362111109800 RISK OF ELECTRIC SHOCK DO NOT OPEN Taking apart or modifying the receiver may lead to electric shock, fire, or damage to the receiver and will void your warranty. MIXED OUTPUT SERIAL NO. MIC 2 MIC 1 + MIC 2 MIC 1 & 2 ¼” UNBALANCED XLR BALANCED 1 AUDIO OUTPUT G3 SERIES Generation 3 AUDIO OUTPUT ® Better Music Builder® Model No.
ANTENNA-B G3 SERIES Generation 3 362111109800 RISK OF ELECTRIC SHOCK DO NOT OPEN Taking apart or modifying the receiver may lead to electric shock, fire, or damage to the receiver and will void your warranty. MIXED OUTPUT AUDIO OUTPUT ® Better Music Builder® Model No.: VM-82U G3 (UHF Microphone) CALIFORNIA, UNITED STATES OF AMERICA E-MAIL: sales@bettermusicbuilder.com w w w. B e t t e r M u s i c B u i l d e r. c o m ENGINEERED AND DESIGN IN U.S.A. SERIAL NO.
HANDHELD MICROPHONE Hand-held CONTROLS AND FUNCTIONS BAT 835.500 1 2 835.500 BAT SYNC 3 UHF WIRELESS SYSTEM VM-82U G3 ALKALINE BATTERY ALKALINE BATTERY AA I AA 4 0 5 I 0 1. INTERCHANGEABLE MICROPHONE HEAD 2. LCD PANEL: Displays system status. 3. IR PORT: Broadcasts signal to receiver to allow communication. 4. BATTERY COMPARTMENT: Insert two AA batteries. 5. POWER: Turns microphone On/Off.
LCD PANEL: After turning on the “POWER”, the LCD panel will light up as below: BAT 835.500 1 2 3 1. FREQUENCY: Shows current frequency. 2. LED (BATTERY POWER INDICATOR): If green light is on, indicates battery power is at normal status. If red light is flashing, indicates low battery. No light means power off or no power. 3. BATTERY STATUS: Shows battery level of microphone. BATTERY STATUS: Full Battery BAT 835.500 Indicates full battery on the microphone.
OPERATION Operation HOW TO SET UP MICROPHONE FREQUENCY Setting up the microphone is quick and easy. Please follow these simple steps: STEP 1: Press UP “▲”/DOWN “▼” on the receiver to select desired frequency. MICROPHONE 2 PEAK VOLUME MIN µV 100 % 100 60 60 25 25 5 5 RF MAX PEAK DEV FREQUENCY SYNC MUTE 850.700 CH:03 SQ:3 ANT A FREQUENCY CHANNEL SQUELCH BOOSTER FREQ STANDBY REMOTE GHz MHz ANT B FREQ POWER SET ESC STEP 2: Open battery compartment on the microphone.
HOW TO LOCK/UNLOCK RECEIVER’S SETTINGS Do the following when the receiver is POWERED OFF. STEP 1: Press and hold SET on the receiver. Do not release it. MICROPHONE 2 FREQUENCY CHANNEL SQUELCH BOOSTER FREQ STANDBY REMOTE VOLUME MIN FREQ POWER SET MAX ESC STEP 2: Then Press POWER on the receiver. MICROPHONE 2 FREQUENCY CHANNEL SQUELCH BOOSTER FREQ STANDBY REMOTE VOLUME MIN FREQ POWER SET MAX ESC STEP 3: After the receiver is on, release both buttons to LOCK/UNLOCK settings.
HOW TO ADJUST MICROPHONE VOLUME Turn VOLUME left to decrease the volume and right to increase the volume on the receiver. MICROPHONE 2 PEAK VOLUME MIN RF MAX Recommend µV 100 PEAK % 100 60 60 25 25 5 5 DEV FREQUENCY SYNC MUTE 850.700 CH:03 SQ:3 ANT A GHz MHz ANT B FREQUENCY CHANNEL SQUELCH BOOSTER FREQ STANDBY REMOTE FREQ POWER SET ESC We recommend setting the microphone volume to a medium position, then control the overall volume from the amplifier/mixer.
HOW TO INSERT/CHANGE BATTERIES OF MICROPHONE STEP 1: Twist and slide open the battery cover. UHF WIRELESS SYSTEM VM-82U G3 STEP 2: Hold the top of the microphone with one hand and with the other hand slide two AA batteries into the battery compartment. ALKALINE UHF WIRELESS SYSTEM VM-82U G3 BATTERY AA Be careful not to drop the microphone while inserting batteries and to follow the polarity of the battery according to the diagram.
HOW TO TURN ON/OFF MICROPHONE TURN ON: Press the power button and release it immediately to turn ON the microphone. Microphone’s LCD panel will display frequency, and battery status. TURN OFF: Press and hold the power button for 3 seconds to turn OFF the microphone. Microphone’s LCD panel will turn off. 3 SECONDS I I ON/OFF 0 0 NOTE If the microphone cannot be powered ON, battery may be low and should be replaced. Typical battery life is up to 8 hours. Battery life may vary depending on usage.
TECHNICAL SPECIFICATION Spec A. TECHNICAL FEATURE OF THE 2-IN-1 BASE MODULE: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Frequency Range: UHF 820~990 MHz Channels: 60 Signal to Noise Ratio: > 90dB Total Harmonic Distortion: ≤ 1% Frequency Response: 80Hz ~ 15KHz (±3dB) Spurious Emission: ≥ 75dB Receiver Sensitivity: 80dB (12dBuV) Audio Output Level: Balanced Out: 0~0.5V/600MA Unbalanced Out: 0~0.
Body-Pack BODY-PACK MICROPHONE SYSTEM SPECIFICATION (Optional) NAMES & FUNCTION: Body-Pack Microphone System (including Lavalier Mic. and Headset Mic.) Outside Picture 1. Antenna 2. 4-pin Microphone Input Jack 3. LCD Digital Display 4. IR Port: Receives infrared beam to synchronize frequencies. IR when using multiple systems, only one microphone port should be exposed at a time 5. Battery Cover 6. Tie-Clip 7.
HOW TO INSERT BODY-PACK MICROPHONE BATTERIES STEP 1: Open battery cover. Good STEP 2: Insert 2 AA batteries. 2 alkaline batteries are expected to use for about 8 hours. Make sure that you insert batteries correctly, as shown in picture. When the microphone body-pack light glows red, the batteries should be changed immediately. AA ALKALINE BATTERY 1 ALKALINE BATTERY AA 2 CLOSE AA ALKALINE BATTERY OPEN HOW TO WEAR BODY-PACK MICROPHONE The microphone can be buckled to the belt or the guitar band.
TROUBLESHOOTING Troubleshooting CAUTION: Before troubleshooting any symptoms, make sure equipments are turned OFF. 1. SYMPTOM: NO SOUND COMING FROM MICROPHONE CAUSE: There is no indication of signal. REMEDIES: A. Battery may be low and should be recharged by placing the microphone onto the CHARGER BASE. B. Microphone and receiver should be in the same channel to allow transmitting and receiving signal. C. Volume is turned to a low level and should be turned to a high but comfortable volume level. D.
4. SYMPTOM: DISTORTION IS INCREASING GRADUALLY. CAUSE: Battery is running low. REMEDIES: A. Recharge battery as soon as possible. B. Make sure to fully charge battery before use. 5. SYMPTOM: POOR SIGNAL. CAUSE: Objects can be disrupting communication between receiver and microphone. REMEDIES: A. Make sure no objects are between receiver and microphone, such as walls and shelves. B. Make sure microphone usage is not in perimeter of police, fire or radio stations. C.
Appendix APPENDIX VM-82U G3 FCC FREQUENCY: 820.000~990.000 MHz UHF Frequencies Available for Use for Home Electronics in North America The RF radio frequencies used in the transmission of wireless information are closely regulated in most countries including North America. A lot of countries strictly enforce their regulations stating which RF frequencies are available for use for certain device, so it can help limit the amount of radio frequency interference in all wireless communications.
MIC 1 & MIC 2 FREQUENCY: 820.000~990.000 MHz MIC 1 FREQUENCY 835~850MHz MIC 2 FREQUENCY 850~865MHz CH FREQUENCY CH FREQUENCY CH FREQUENCY CH FREQUENCY 1 835.500 16 842.525 1 849.950 16 857.300 2 836.300 17 842.850 2 850.425 17 857.875 3 836.650 18 843.450 3 850.700 18 858.225 4 837.250 19 843.825 4 8511.00 19 858.650 5 837.700 20 844.300 5 851.500 20 859.100 6 838.250 21 844.800 6 852.225 21 859.500 7 838.475 22 845.100 7 852.725 22 859.
WARRANTY Warranty One-Year Limited Warranty for Home Use Equipment Our one-year warranty applies to speakers, amplifiers, mixers and microphones for home use only. It covers both parts and labors. The warranty becomes effective on the date of your purchase. Our warranty only covers defects due to product defectiveness with free of defects in materials or workmanship.
CONTACT INFORMATION Contact Us MAILING ADDRESS BETTER MUSIC BUILDER 29300 Kohoutek Way #150 Union City, CA 94587 U.S.A. TELEPHONE NUMBERS USA Region USA Toll Free: 1-800-318-2218 Sales & Marketing: 510-477-9955 Customer Service: 510-477-9955 FAX NUMBERS USA Region Sales & Marketing: 510-477-9922 Customer Service: 510-477-9922 WORLD WIDE WEB E-mail: sales@bettermusicbuilder.com Website: www.bettermusicbuilder.
MAINTENANCE NOTE 23
Better Music Builder is a leader in the Audio and Karaoke equipment industry. We are committed to offering you high quality audio products. We may update our manual, so we highly recommend you to download the free update from our website at www.BetterMusicBuilder.com. ® ® Unlike any others ... that’s cost & value for you Passionate about Music www.BetterMusicBuilder.com 364110609200 362111109800 Code: 20111122 Printed on 100% Recycled Paper Comments E-mail to sales@bettermusicbuilder.
