Instruction manual

Administering customer logins and forced password
aging
Issue 9 May 2003
13-13
■ Calls Used
This field is a display-only field that specifies the number of calls that
have been placed using the corresponding barrier code. The
Calls
Used
field is incremented each time a barrier code is successfully
used to access the Remote Access feature.
NOTE:
A usage that exceeds the expected rate may indicate improper
use.
■ Permanently Disable
Enter y to permanently disable the Remote Access feature. The
Remote Access screen will no longer be accessible.
■ Disable following a Security Violation?
Enter
y to disable the Remote Access feature following a remote
access security violation. The system administrator may re-enable
Remote Access with the
enable remote-access command.
Administering customer logins and
forced password aging
This section contains the following subsections:
■ Adding customer logins and assigning initial password
■ Changing a login’s attributes
■ Administering login command permissions
Adding customer logins and assigning initial
password
For DEFINITY G3V3 and later releases, the two types of customer logins are:
■ superuser—Provides access to the add, change, display, list, and
remove commands for all customer logins and passwords.
The superuser can administer any mix of superuser/nonsuperuser logins
up to ten system logins.
■ nonsuperuser—Limits permissions according to restrictions specified by
the superuser when administering the non-superuser login.
A nonsuperuser may change his/her password with permission set by the
superuser; however, once a password has been changed, the
nonsuperuser must wait 24 hours before changing the password again.
The superuser may administer up to 10 non-superuser logins.