Instruction manual

Administering barrier code aging
Issue 9 May 2003
13-11
■ Announcement Extension
This field contains an extension corresponding to a recorded
announcement that is to be played whenever a station security code
SVN referral call is made. This allows the referral destination to be a
phone without a display. This is a dynamic field that is displayed
whenever the corresponding
SVN Violation Notification
Enabled
field is set to y. Enter a 5-digit extension to be assigned to
the appropriate announcement.
Administering barrier code aging
To administer the Barrier Code Aging feature:
1. Log in with the proper permissions and display the Remote Access screen
by entering the command change remote-access.
2. Once the Remote Access screen is displayed, administer Remote
Access/Barrier Code Aging by filling in the following fields:
■ Remote Access Extension
Enter an extension number (not a VDN extension) for remote
access. This extension is associated with each trunk that supports
the Remote Access feature. The default for this field is blank.
The remote access extension is used as if it were a DID extension.
Only one DID extension may be assigned as the remote access
extension. Calls to that number are treated the same as calls on the
remote access trunk.
When a trunk group is dedicated to remote access, the remote
access extension number is administered on the trunk group’s
incoming destination field.
■ Barrier Code Length
Enter the desired barrier code length (4 to 7 digits), or leave this field
blank indicating that a barrier code is not required. Assigning a
barrier code length of
7 provides maximum security.
■ Authorization Code Required
Enter y if an authorization code must be dialed by Remote Access
users to access the system’s remote access facilities. The default
for this field is
n. Use of an authorization code in conjunction with
barrier codes increases the security of the Remote Access feature.
■ Remote Access Dial Tone
This field appears on the form if the Authorization Code
Required
field has been set to yes. Enter y in this field if remote
access dial tone is required as a prompt to the user. For maximum
security do not use authorization code dial tone.