Instruction manual

Administering the SVN feature
Issue 9 May 2003
13-5
■ Login Threshold
Enter the minimum number of login attempts that will be permitted
before a referral call is made. The value assigned to this field, in
conjunction with the
Time Interval field, determines whether a
security violation has occurred. The system default is
5.
■ Time Interval
Enter the time interval within which a login security violation must
occur. The range is one minute to eight hours (0:01 to 7:59), and is
entered in the form x:xx. For example, if you want the time interval to
be 1 minute, enter
0:01. If you want the time interval to be seven
and one-half hours, enter
7:30. The system default is 0:03.
■ Announcement Extension
Enter an extension that is assigned to the SVN announcement. The
announcement must be recorded for the SVN referral call to be
made. A repeating announcement is suggested, especially if the
SVN referral call might go to an answering machine.
3. To activate the Disable Following A Security Violation feature, display the
Remote Access screen and enter
y in the Disable Following a
Security Violation
field.
4. For releases before G3V3, administer an “rsvn-call” button on any
station/attendant console (maximum 1 per system).
The SVN button location can be determined by entering the command
display svn-button-location. Activation of this feature button initiates the
placement of referral calls, until the button is deactivated.
5. For G3V3 and later releases, administer an “rsvn-halt” button on any
station/attendant console (maximum 1 per system).
The SVN button location can be determined by entering the command
display svn-button-location. Activation of this feature button stops the
placement of all referral calls until the button is deactivated.
Enable/disable remote access code
To enable a remote access code that has been disabled following a security
violation, or disabled manually with the
disable remote-access command:
1. Log in to the switch using a login ID with the proper permissions.
2. Enter the command
enable remote-access.
To disable a remote access code:
1. Log in to the switch using a login ID with the proper permissions.
2. Enter the command
disable remote-access.