Instruction manual

Voice messaging systems
7-38 Issue 9 May 2003
MERLIN LEGEND Communications
System
The MERLIN LEGEND Communications System may be used with the following
voice messaging systems:
■ AUDIX Voice Power System — the AUDIX Voice Power System is a
system that is external to the MERLIN LEGEND Communications System
and connected to the switch by station lines and data links. (See
‘‘Protecting the AUDIX Voice Power System’’ on page 7-39
.)
■ INTUITY Voice Messaging System (See ‘‘Protecting the INTUITY Voice
Messaging System’’ on page 7-41.)
■ MERLIN MAIL Voice Messaging System. (See ‘‘Protecting the MERLIN
MAIL, MERLIN MAIL-ML, MERLIN MAIL R3, and MERLIN LEGEND Mail
voice messaging systems’’ on page 7-45.)
■ MERLIN MAIL-ML Voice Message System. (See ‘‘Protecting the MERLIN
MAIL, MERLIN MAIL-ML, MERLIN MAIL R3, and MERLIN LEGEND Mail
voice messaging systems’’ on page 7-45.)
■ MERLIN MAIL R3 Voice Message System. (See ‘‘Protecting the MERLIN
MAIL, MERLIN MAIL-ML, MERLIN MAIL R3, and MERLIN LEGEND Mail
voice messaging systems’’ on page 7-45.)
■ MERLIN LEGEND Mail Voice Messaging System. (See ‘‘Protecting the
MERLIN MAIL, MERLIN MAIL-ML, MERLIN MAIL R3, and MERLIN
LEGEND Mail voice messaging systems’’ on page 7-45.)
■ Messaging 2000 Voice Mail System (See ‘‘Maintaining Message 2000
system security’’ on page 7-50.)
Also see ‘‘Related documentation’’ in the ‘‘About this document’’ section
for a list
of manuals on these products.
The MERLIN LEGEND Communications System ships with ARS activated and all
extensions set to FRL 3, allowing all international calling. To prevent toll fraud,
ARS FRLs should be established using:
■ FRL 0 for restriction to internal dialing only
■ FRL 2 for restriction to local network calling only
■ FRL 3 for restriction to domestic long distance (excluding area code 809 for
the Dominican Republic, as this is part of the North American Numbering
Plan, unless 809 is required)
■ FRL 4 for international calling
Each extension should be assigned the appropriate FRL to match its calling
requirement. All voice mail port extensions and barrier codes not used for
outcalling should be assigned to FRL 0, which is the default setting for voice mail
ports starting with Release 3.1. Prior to this release, the default setting is FRL 3.