Instruction manual

Communication Manager, MultiVantage Software,
DEFINITY ECS, DEFINITY communications systems,
System 75,and System 85
Issue 9 May 2003
7-11
■ If the Tenant Services feature is used, use PROC314 WORD1 to map
routing designators to patterns. If tenant services is not used, the pattern
number will be the same as the routing designator number.
■ Use PROC309 WORD3 to define the restricted and unrestricted patterns.
For Communication Manager, MultiVantage™ Software, DEFINITY ECS and
DEFINITY G3:
■ Use change ars analysis to display the ARS Analysis screen.
■ Enter the area codes or telephone numbers that you want to allow and
assign an available routing pattern to each of them.
■ Use change routing pattern to give the pattern preference an FRL that is
equal to or lower than the FRL of the voice mail ports.
NOTE:
For DEFINITY G3, the Unrestricted Call List (UCL) on the Toll Analysis table
can be used to allow calls to specified numbers through ARS/WCR. The
COR for the voice mail ports should show “all-toll” restriction and access to
at least one UCL.
For DEFINITY G2.2:
■ Use PROC314 WORD1 to assign a VNI to the unrestricted dial string. Map
the VNI to a routing pattern in
PROC317 WORD2, and assign a low FRL to
the pattern in
PROC318 WORD1. If you permit only certain numbers,
consider using Network 3, which contains only those numbers.