Instruction manual

Voice messaging systems
7-10 Issue 9 May 2003
For DEFINITY G2 and System 85:
■ Use PROC010 WORD3 FIELD23 to assign FRLs for use with
AAR/ARS/WCR trunks. Assign higher FRLs to restricted patterns in
PROC309 than the FRL in the COS for the voice mail ports.
■ For DEFINITY G2.2, do not use PROC314 to mark disallowed destinations
with a higher FRL value.
PROC314 WORD1 assigns a Virtual Nodepoint
Identifier (VNI) to the restricted dial string.
PROC317 WORD2 maps the
VNI to the pattern, and
PROC317 WORD2 shows the pattern preference,
with the FRL in field 4.
For earlier releases, use PROC313 to enter disallowed destinations in the
Unauthorized Call Control table.
Allow calling only to specified numbers
A reverse strategy to preventing calls is to allow outbound calls only to certain
numbers. For G1 and System 75, you must specify both the area code and the
office code of the allowable numbers. For G3, you can specify the area code or
telephone number of calls you allow.
For DEFINITY G1 and System 75:
■ Use change ars fnpa xxx to display the ARS FNPA Table, where xxx is
the NPA that will have some unrestricted exchanges.
■ Route the NPA to an RHNPA table (for example, r1).
■ Use change rnhpa r1: xxx to route unrestricted exchanges to a pattern
choice with an FRL equal to or lower than the originating FRL of the voice
mail ports.
■ If the unrestricted exchanges are in the Home NPA, and the Home NPA
routes to
h on the FNPA Table, use change hnpa xxx to route unrestricted
exchanges to a pattern with a low FRL.
NOTE:
If assigning a low FRL to a pattern preference conflicts with requirements for
other callers (it allows calls that should not be allowed), use ARS partitioning
to establish separate FNPA/HNPA/RHNPA tables for the voice mail ports.
For DEFINITY G2 and System 85:
■ Use PROC311 WORD2 to establish 6-digit translation tables for foreign
NPAs, and assign up to 10 different routing designators to each foreign
NPA (area code).
■ Use PROC311 WORD3 to map restricted and unrestricted exchanges to
different routing designators.
■ If the unrestricted toll exchanges are in the Home NPA, use PROC311
WORD1
to map them to a routing designator.