Instruction manual

Communication Manager, MultiVantage Software,
DEFINITY ECS, DEFINITY communications systems,
System 75,and System 85
Issue 9 May 2003
7-9
NOTE:
In Table 7-2, FRLs 1 through 7 include the capabilities of the lower FRLs.
For example, FRL 3 allows private network trunk calls and local calls in
addition to FX and WATS trunk calls. Verify the route pattern FRLs — no
pattern should carry an FRL of 0.
For DEFINITY G1, G3, and System 75:
■ Use change cor for the voice mail ports (versus subscribers) to display the
Class of Restriction screen.
■ Enter the FRL number (0 through 7) in the FRL field. Assign the lowest FRL
that will meet the outcalling requirements, if the Outcalling feature is being
utilized. The route patterns for restricted calling areas should have a higher
FRL assigned to the trunk groups.
■ Use change route-pattern to display the Route Pattern screen.
■ Use a separate partition group for ARS on the ports used for outcalling,
and limit the numbers that can be called.
NOTE:
For Communication Manager, MultiVantage™ Software, DEFINITY ECS
and DEFINITY G3, the Restricted Call List on the Toll Analysis table can
also be used to restrict calls to specified areas.
Table 7-2. Suggested values for FRLs
FRL Suggested Value
0 No outgoing (off-switch) calls permitted.
1 Allow local calls only; deny 0+ and 1 800 calls.
2 Allow local calls, 0+, and 1 800 calls.
3 Allow local calls plus calls on FX and WATS trunks.
4 Allow calls within the home NPA.
5 Allow calls to certain destinations within the continental USA.
6 Allow calls throughout the continental USA.
7 Allow international calling. Assign attendant console FRL 7. Be
aware, however, if Extension Number Portability is used, the
originating endpoint is assigned FRL 7.
Continued on next page