Instruction manual

Small business communications systems
6-48 Issue 9 May 2003
■ Assign all unused automated attendant selector codes to go to either the
operator or the general mailbox.
■ See “Check voice mail ports for Merlin Mail, Merlin Legend Mail, Merlin
Messaging, Audix, automated attendant (stand alone), or CPE (customer
provided equipment),” page 6-46
and “Make disallowed lists for voice
ports,” for other restrictions”, page 6-46
.
Automated attendant – stand-alone.
■ Make ports outward restricted.
■ Restrict transfer to available extensions only (set for lowest and highest
extension digits.)
■ Set the maximum number of digits to match the dial plan.
■ Change the default system password.
CPE (customer premise equipment – PBX [non Lucent/Avaya])
■ Make ports outward restricted.
■ Check with vendor for toll fraud security.
Lines/Trunks.
■ Remote access: see step A. above.
■ Loop start.
■ Reliable disconnect = YES: signal sent by local company.
■ Reliable disconnect = NO: no signal sent by local company.
■ Remote Call Forward can not be used with reliable disconnect =
NO.
■ Trunk to trunk transfer can have problem with reliable disconnect =
NO.
■ T1 does not respond to reliable disconnect.
■ IS3 defaults to reliable disconnect = YES.
■ Toll fraud security can not be assured.
DID (Direct Inward Dial). Should not end with the same number as the pool dial
out codes (70, 890 – 899)
TIE (400 EM and/or 100D DS1)
■ Outward or toll restrict if possible.
■ ARS restrict.
■ Use barrier codes if possible.
■ Assign disallowed list.
■ Assign allowed list.