Owner`s manual

SYSTEM APPLICATIONS

CONNECTING THE SPEAKERS

HOW TO CONNECT THE SPEAKER TO AMPLIFIER

We at Better Music Builder always provide you the technical

support and relevant information to help you make the best

use of your audio equipment. To avoid damages in

connection mistakes please refer to the following three

diagrams showing our recommended connections for the

different speaker impedance.

Applications

8 ohm transformer (amplifier output)

8 ohm8 ohm

SERIES WIRING

4 ohm transformer (amplifier output)

4 ohm4 ohm

PARALLEL WIRING

8 ohm transformer (amplifier output)

8 ohm8 ohm

SERIES / PARALLEL WIRING

NO GOODGOOD

METHODS OF SPEAKER CONNECTION

Either banana plug or insert type can be used to connect the

unit to speakers. Be sure to connect red (+) to red (+) and

black (–) to black (–). Otherwise, the sound output would be

180° out of phase and distorted.

Follow these steps if you are inserting the wire directly into the

speaker terminal.

1. Strip off the vinyl covering and twist the tip of the wire core.

2. Loosen the knob and insert the wire core into the

terminal hole.

3. Tighten the knob to fix the wire core in place.

Do not allow the wire core to protrude or touch other terminals

or wires. If the cores of differing wires touch, damage may

result to your components.

1. Insert Type (Standard Connection)

2. Single Banana Plug Type (Better Connection)

3. Double Banana Plug Type (Best Connection)

3/4”

19 mm

Please turn off amplifier power prior to connection.

NOTE