Operating Guide

Figure 10

E. Installing the BENCH HEAT EMITTER PANEL and BENCH

1. Installing the BENCH HEAT EMITTER PANEL can be a little tricky. You will need to slide the

BENCH HEAT EMITTER PANEL into place at an angle as indicated in the pictures below.

(see Figure 11)

2. Plug in the BENCH HEAT EMITTER connector to the corresponding inlet located on the

REAR WALL or SIDE WALL PANEL. Also plug in the FLOOR HEAT EMITTER PANEL

connector to the corresponding inlet on the REAR WALL or SIDE WALL PANEL.

3. Install the BENCH at an angle as also seen in Figure 11. Then slide it over the horizontal

bench guides on the side panels. Slide the BENCH all the way in and against the REAR

WALL PANEL. Make sure to install the BENCH with the smooth and finished side facing

upward. If screws were provided, use them to screw down the bench.

Figure 11