How to Guide

M. Installing the CD/RADIO (optional)

1. Unscrew the lock screws on the top of CD player. (see figure 27)

2. Connect the plug from the CD/RADIO with the plug coming down from the roof and the left/right

speaker plugs. (see figure 28)

3. Connect the antenna plug to the CD/RADIO. (see figure 29)

4. Insert the CD/RADIO into the RADIO BOX. It is not necessary to mount the CD/RADIO once

you slide it into the RADIO BOX because the radio will just sit in place. (see figure 30)

Figure 27 Figure 28

Figure 29 Figure 30

Operating the Sauna

NOTE: Before the sauna is turned on, remove plastic protective covering from the

CONTROL PANELS. Please check and confirm that the connections to the POWER

SUPPLY, HEAT EMITTERS, CD/RADIO, and TEMPERATURE SENSOR are connected

properly. The power supply voltage and frequency must match the requested voltage

and frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC 20AMP

Dedicated Circuit).

Since many materials absorb the infrared rays, minimal clothing is recommended for

maximum effect. The infrared sauna emitters are designed to heat you and not

necessarily the air inside the sauna. It is not a hot box like a traditional sauna. The

temperature gauge is a guide for your safety. It is recommended that you drink water

before, during, and after sauna use to prevent dehydration since body fluids will be lost

through perspiration. It is not recommended to shower after use since the pores in your

skin will be open and could possibly absorb anything in the water.