Owner's Manual

4.2 Remote Control
Pairing Betta with a New Remote
The remote control packed with Betta has been paired in the factory.
You only need to do this step if it doesn’t work, or you replaced it with a new one.
First, slide the power to “OFF” position to turn off the unit. Second, slide the switch to “ON” to
turn it on. Press any button once on the remote control within 5 seconds after you turn on the
unit. Test the buttons on the remote after the 5 seconds and see if the unit is moving
accordingly. If yes, the paring completes. If not, repeat this process from the beginning. If no
success on paring, please contact Betta customer service.
Using Remote Control
You should be able to use the remote control out of the box since it’s paired with your
Betta in the factory. You only need to pair it if it doesn’t work, or you replaced either the
Betta unit or the remote control.
Press any button on the remote control. Betta will instantly enter Remote Control Mode.
Press and hold the left button to move Betta left, press and hold the right button to move
Betta right, so on and so forth.
To go back to Auto Mode, press the middle button down for 2 seconds, and Betta will go
back to Auto. Also, if you do not operate Betta with the remote control for 2 minutes, it will go
back to Auto Mode by itself.
4.3 LED Light Status Indicator
LED light status indicators (one on each side at front) will show the operation status
information of working conditions of the unit.
Standard Mode: lights flash in Green.
Status: there is enough power, the unit will keep running.
Intermittent Mode: lights flash in Red.
Status: the battery is low; the unit is running at irregular intervals in attempts
to locate sunlight where it can be recharged.
Sleep Mode: all indicator lights are off.