Betta® 2 Smart Pool Skimmer Owner’s Manual www.BettaBot.com 888-692-3882 (888-MyBetta) 562-579-0001 info@BettaBot.
1. Important Safety Instructions l DO NOT SWIM while Betta is working in the pool. Take it out of the pool and keep it at a cool place under the shade when the pool is in use. l Betta Smart Pool Skimmer is NOT a toy. Keep it away from children. l Be sure to watch your steps and maintain your balance when working by the pool side. l Do not use while other pool cleaning devices are in the pool.
Parts List 1. Cover Lock 7. Solar Panel 2. Distance Measure Sensor 8. Power Switch 3. LED Status Indictor 9. Cover 4. Guide Wheel 10. Debris Collection Basket 5. Propeller 11. Debris Intake Impeller 6. Anti-stranding Bar 12. Handle 4. Using the Pool Cleaner 4.1 Using the unit for the first time Note: Betta ONLY takes solar charge when power switch is ON Be sure to watch your steps and maintain your balance when working by the pool side. Step 1.
.2 Remote Control Pairing Betta with a New Remote The remote control packed with Betta has been paired in the factory. You only need to do this step if it doesn’t work, or you replaced it with a new one. First, slide the power to “OFF” position to turn off the unit. Second, slide the switch to “ON” to turn it on. Press any button once on the remote control within 5 seconds after you turn on the unit. Test the buttons on the remote after the 5 seconds and see if the unit is moving accordingly.
Status: the battery is very low, or battery becomes completely discharged. Remote Mode: lights are in steady Green. Status: the unit is controlled manually via a remote control. Strand Mode: lights flash in combination of Red and Green. Status: the unit's propellers or impeller is not working properly, most likely it has been stuck by obstacles or cannot run freely. In this case it will stop running automatically. The unit will try to restart every 20 minutes when it is in Strand Mode. 4.
4.5 Battery Run Time during Winter During winter months, the battery may not get a full charge because the sunlight is not as strong as during summer. Therefore, you should expect Betta to have a shorter run time than in the summer. Even in a sunny winter climate like CA, FL, and AZ, you will not get as fast charge as in the summer, and a full charge will need a longer period. 5.
with hose water, let it completely dry, and keep it indoor at room temperature in a dry place away from high heat. Before the first use of the next season, check all the parts of Betta for signs of trouble before putting it back in use. Turn power on when ready to use. 6. Troubleshooting Note: Betta ONLY takes solar charge when power switch is ON Below is some info that should help your daily use of Betta. Problem Possible reason What to Do Not running at night The unit is in Sleep Mode.
The unit is moving in circles Can't be controlled by remote One or both propellers are trapped which makes the unit running unbalanced. If the light on remote control is not lit when press any button, remote control batteries are low. Check propellers and Impeller for dirt, string, and hair. Replace remote batteries (2x AAA). Remote unit is not paired with Betta. Try paring the remote control with Betta unit again. Betta may be in Sleep Mode when battery charge is extra low or completely discharged.
