Installation Instructions

FormoreinformationabouthowtoenterandoperateOSDmenu,pleaserefertothechapter“OSDMenu
Operation”;
RemoteControlRadioTransmitterCalibration
Afterrepeateduseoriftheremotecontrolradiotransmitterissubjectedtophysical
impact,thejoysticksmaynolongerreadcorrectlyandrequirerecalibration.
●
Afterpoweringon,presstheSETUPbuttononthebackoftheremotecontrolradio
transmitterwhichwillbeeptwice,andLEDwillquicklyflashredtwice.Theremote
controlradiotransmitterhasenteredcalibrationmode.
●
Movethrottlejoystickanddirectionjoysticktomiddleposition.PressSETUP button
againandwaituntiltheremotecontrolradiotransmitterbeepsthreetimes.Thered
LEDwillflashtwicequickly.Thisindicatesjoystickscenterdatahasbeenacquired.
●
Slowlyrotatethethrottleanddirectionjoysticktwicearoundtheboundaryofthe
joysticks(oncecounterclockwiseandonceclockwise),thenpressSETUPbuttonagain.
Theremotecontrolradiotransmitterwillemitabeepforabout3secondsandLEDwill
stopflashing.Calibrationhasbeencompletedsuccessfully.