Installation Instructions

remotecontrolradiotransmitterfor5secondsuntilitbeepsthreetimes,thenrelease.
Theremotecontrolradiotransmitterpowerindicatorwillquicklyflashred,then
remainblue , which means it is powered on.
●
Step2:Installthebatteryintothebatterymountingslotunderthequadcopter.
Ensure that thedirectionofthebattery interface and that of the quadcopter power
cordisconsistent . Connectthequadcopter with the battery,thenplacethe
quadcopteronalevelfloor.Wait2-3secondsuntilitsstatusLEDlightstoremainblue
which indicates that the initialization of the quadcopter is complete and it is
connected with the remote control radiotransmitter .
●
Step3:MoveswitchSAuptoarmthequadcopter.Thethrottlejoystickmustbe
atthelowestpositionorthequadcopterwillnotarm.Themotorswillspinslowly.
MoveswitchSAdowntodisarmthequadcopter and the motors will stop spinning .