Installation Instructions

The flight mode is selected by a switch on the remote control transmitter. For more details,
please refer to the chapter “ Remote control operation-introduction to switch functions ”
Caution:Pleasekeeptheflightaltitudewithin0.3-3mwhenitisintheAdaptionmode. This
can keep the quadcopter fly stably. O therwise,itmightcauseanunstableflyingexperience.
BatteryCharging
Eachbatteryprovides3-4minutesofsmoothflight.WhenLOWVOLisdisplayedontheOSD
flightinterfaceandthestatusLEDonthequadcopterchangestoflashingred,thebatteryis
toolowandneedstobecharged.Chargingstepsareasfollows:
●
P lugthechargerintotheType-C port th rough USB;
●
Connectoneortwobatteriestothe port on the right of the charger and the
charger ’sLED turns solidredwhencharging ;
●
Whenthecharger’sLED turns solidgreen, charging is complete;
Thechargercancharge2batteriesat the same time . Chargingafullydischarged battery
takesapproximately20minutes . WhenthebatteryisinsertedintotheTESTportandthe