User`s manual

3-18 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
3
Cables
Five cables are available for the DSM314:
Table 3-7. Cables for the DSM314
Cable Description Length Application
IC693CBL316 Station Manager Cable 1 meter DSM314 Comm for firmware upgrade
IC693CBL324 Terminal Board Connection Cable 1 meter DSM314 to Servo Axis Terminal Board or
Aux Terminal Board
IC693CBL325 Terminal Board Connection Cable 3 meters DSM314 to Servo Axis Terminal Board or
Aux Terminal Board
IC800CBL001 Digital Servo Command Cable 1 meter Digital Servo Axis Terminal Board or DSM
to Digital Servo Amp
IC800CBL002 Digital Servo Command Cable 3 meters Digital Servo Axis Terminal Board or DSM
to Digital Servo Amp
Custom Terminal Board and Servo cables are available in longer lengths by
contacting your GE Fanuc distributor
.
The maximum recommended cable length for
the DSM connector to the
α
and
β
Series servo amplifier is 50 meters.
The cables use special shielding and construction to ensure reliable servo
operation. GE Fanuc recommends that users do not attempt any field
modifications of the cables or connectors.
Note
If a Digital Servo Axis does not use any of the devices which normally
connect to the IC693ACC335 Digital Servo Terminal Board screw
terminals, the Terminal Board and Terminal Board Cable
IC693CBL324/325 are not needed. Instead, the Digital Servo Command
Cable IC800CBL001/002 can be connected directly from the Digital Servo
Amplifier to the DSM314 faceplate A or B connector. When this is done,
the
OT Limit Sw
configuration parameter must be set to
Disabled
in the
configuration software or the DSM will not operate.