User`s manual

Installation and Wiring
GFK-1742A Chapter 3 Installing and Wiring the DSM314 3-15
3
Auxiliary Terminal Board - IC693ACC336
Description and Mounting Dimensions
The IC693ACC336 Auxiliary Terminal Board is used to connect the DSM314 to Analog Servo
Axes and auxiliary devices such as Incremental Quadrature Encoders, Strobe detectors and
external switches. The board contains one 36 pin connector, labeled
DSM
. A cable IC693CBL324
(1 meter) or IC693CBL325 (3 meters) connects from the
DSM
connector (PL2) to the DSM314
faceplate.
Thirty-eight screw terminals are provided on the Auxiliary Terminal Board for connections to
user devices. These screw terminals have the same pin labels as the 36 pin DSM314 faceplate
connector. Refer to Chapter 3 for detailed connection information.
The maximum voltage that should be applied to I/O terminals 16-18 and 34-36 is 30 VDC.
The maximum voltage for any other input terminal is 5 VDC.
Six 130V MOVs are installed between selected I/O points and the shield (frame ground) for
noise suppression. The I/O terminal points so connected are 16, 17, 18, 34, 35, and 36.
The I/O terminals support a wire gauge of 14-28 AWG. Maximum screw torque which may
be applied is 5 inch-pounds.
Note
Two of the screw terminals are labeled
S
for
Shield
. A short earth ground wire
should be connected from one of the
S
terminals directly to a panel earth
ground. The cable shields for any shielded cables from user devices should
connect to either of the
S
terminals.
S21354687911 101214 131517 1618
S20 192123 222426 252729 283032 313335 3436
1.8" (45mm)
4.95"
(125mm)
Height
Above Panel
1.95"
(48mm)
DIN-Rail Mount
S21354687911 101214 131517 1618
S20 192123 222426 252729 283032 313335 3436
0.9"
(22.5mm)
Height
Above Panel
1.65"
(42mm)
Panel Mount
5.42"
(125mm)
5.6"
(141mm)
0.368" (9.3mm)
Counterbore Dia.
0.176" (4.5 mm) Thru. Dia.
Figure 3-7. IC693ACC336 Terminal Board Mounting Dimensions