User`s manual

3-14 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
3
Figure 3-6. Digital Servo Axis Terminal Board Assembly Side View
The following procedure should be used to convert the Digital Servo axis terminal board to its
panel mounting form. Remember to save all removed parts for possible later conversion back to
DIN-rail mounting.
1
.
Carefully remove one UMK-SE 11.25-1 side element from the UMK-BE 45 base element. If
a screwdriver or other device is used, exercise extreme caution to avoid damaging either the
plastic parts or the circuit board.
2
.
Slide the UMK-FE foot element off the base element. Save this part for possible future use in
converting the terminal board back to its DIN-rail mounting configuration.
3
.
Snap the side element, removed in step 1 above, back into the base element.
4
.
Insert one UMK-BF mounting ear into the appropriate two holes in the side element. Note
that the mounting ear has a recessed hole for later inserting a (user supplied) mounting screw.
The recessed hole should face upwards to accommodate the mounting screw.
5
.
Repeat steps 1-4 above for the other side of the terminal board.