User`s manual

Installation and Wiring
GFK-1742A Chapter 3 Installing and Wiring the DSM314 3-9
3
1. For Analog servos, it connects to DSM Connector A, B, C or D to provide screw
terminals for wiring to a third party Analog servo amplifier and I/O devices. See
Figures 3-19 through 3-23.
2. For Auxiliary axes, it connects to DSM Connector B, C, or D to provide screw
terminals for wiring to external devices such as Strobe sensors, Home switches, and
Overtravel Limit switches. Note: See Figure 3-23.
•
SL-Series Servo to APM/DSM Terminal Board, Catalog IC800SLT001
– Used to
connect DSM connector A, B, C or D to a GE Fanuc SL-Series analog servo
amplifier, as well as provide screw terminals for wiring to I/O devices. It contains
two connectors. One connects to the DSM module, and the other to the SL-Series
Servo amplifier. For additional information, please see the
SL-Series Servo User’s
Manual
, GFK-1581.
DSM Terminal Board Quick Selection Table
DSM Application
DSM
Connector
DSM Axis
Mode
Terminal
Board
Required
Connect to
α
-Series or
β
-Series digital
servo and I/O.
A or B Digital IC693ACC335
Connect directly to
α
-Series or
β
-Series
digital servo. No I/O connections needed.
A or B Digital None
Connect to third party analog servo and I/O. A, B,C or D Analog IC693ACC336
Connect to SL-Series analog servo and I/O. A,B,C or D Analog IC800SLT001
Connect to Auxiliary Axis I/O on DSM
connector B, C or D
B,C or D Analog or Aux IC693ACC336
S21354687911 101214 131517 1618
S20 192123 222426 252729 283032 313335 3436
S21354687
S10 91113 121416 15
IC693ACC335
Servo AxisTerminal Board
IC693ACC336
Auxiliary Terminal Board
Figure 3-3. Axis and Auxiliary Terminal Board Assemblies
Note
Each Terminal Board is shipped with DIN Rail mounting feet. Instructions for
converting a terminal board to panel-mount are included in this chapter.