User`s manual

2-40 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
2
Section 7: Next Steps to Take
After successfully moving an axis, what’s next?
This startup chapter does not cover all aspects of the DSM314 motion system. For this reason, you
should review the information provided in all the manuals (see
Related Publications
in the Preface
of this manual). Additionally, GE Fanuc offers applicable training courses. If your application
requires a custom machine interface, you should also attend a GE Fanuc programming course. For
information about training, call 1-800-GE FANUC or contact your GE Fanuc Sales representative.
The installation and wiring chapter of this manual will be your guide to completing the DSM
hardware installation.
The configuration chapter will provide details needed to configure the DSM module for your
application. You should begin by reviewing the
Configuration Parameters
section in chapter 4.
…..
Two final recommendations
:
Save the paperwork that came with your system.
The
Important Product Information
sheet will contain the latest information on this product,
some of which may not be included in this manual.
Back up your ladder logic folder.
Important!
. . . .
Do this frequently while developing your application.