User`s manual

2-30 Motion Mate™ DSM314 for Series 90™-30 PLCs User's Manual – January 2001 GFK-1742A
2
Figure 2-24. Hardware Configuration 90-30 rack with CPU364
At this point, we need to add the DSM314 into the rack. To perform this step, select the rack slot
where the DSM314 is to be installed. In our example, we are going to install the DSM314 in slot
number 2. As such, we want to add the DSM314 module to this slot location. There are several
ways to add modules to a rack slot. Consult the VersaPro documentation for additional details and
procedure. Two methods to add the module are as follows. The user can either double click the
desired slot (in this case slot number 2) or select Edit from the main menu then select Module
Operations from the Edit submenu, and then select Add Module from the Module Operations
menu. At this point a dialog box will be generated that allows the user to select the type module
they wish to add. In our case, we want to add a module of type “Motion”. Therefore, we need to
select the “Motion” tab from the dialog box. At this point, select the DSM314 module from the
list. The resulting display will be as shown in Figure 2-25.
Figure 2-25. Hardware Configuration 90-30 rack DSM314 Selection
This operation will add the DSM314 to the rack and bring up the DSM314 configuration screens.
This will allow the user to customize the DSM314 to their particular application. The reader
should reference chapter 4 for details concerning the DSM314 configuration settings.